Manual

See
Cause Remedy
page
BASS OUT in SUBWOOFER SET is set to Select SWFR. 64
FRONT.
----.__.__
Problem
No sound from the
subwoofer.
Distorted or too little bass
sound.
Too much bass sound.
Surround sound effects are
insubstantial.
Dolby Digital or DTS sources
cannot be played back.
(Dolby Digital or DTS
indicator does not light up in
the front panel display.)
There is noise interference
when a subwoofer is not
connected to this unit.
The source does not contain low bass
signals.
CROSS OVER in SUBWOOFER SET is set Set CROSS OVER correctly. 64
incorrectly.
One of the night listening enhancers is Turn oft" the night listening enhancers.
54
currently selected.
TruBass is currently turned on. Turn off TruBass. 65
The volume level of the subwoofer is too Turn clown the volume level of the
high. subwoofer.
The listening room is not a regular shape. Install this unit in a square or rectangular --
shaped room.
There is no wall in the path of the sound
beam.
The connected component is not set to
output Dolby Digital or DTS digital signals.
The input mode is set to ANALOG.
The protection circuitry was in operation
because a source with strong bass elements
was played back.
Try placing a fiat object, such as a board, in
the path of the sound beam.
The TV does not accept the multi-channel
audio signals.
Make an appropriate setting following the
operating instructions for your component.
Set the input mode to AUTO.
Turn clown the volume level.
Select SWFR IUr BASS OUT.
Connect a subwoofer and adjust settings IUr
SUBWOOFER SET.
Set CROSS OVER correctly.
73
Convert the nmlti-channel audio signals to
the 2-channel audio signals at the source
component such as a DVD player.
44
64
64
Low-frequency sounds are CROSS OVER in SUBWOOFER SET is set 64
distorted, incorrectly.
On-screen display does not The OSD video pin cable is not connected Connect the cable properly. 18, 19
appear, properly.
This unit does not operate The internal microcomputer has been frozen Disconnect the AC power supply cable from --
properly, by an external electric shock (such as the outlet and plug it in again alter about 30
lightning or excessive static electricity) or seconds.
by a power supply with low voltage.
No sound is heard from the
TV connected via HDMI.
"SUPPORT AUDIO" is set to "YSP-600". Set "SUPPORT AUDIO" to "OTHER". 67
There is noise interference This unit is too close to the digital or high- Move this unit farther away from such
from digital or high- frequencyequipment, equipment.
frequency equipment.
This unit does not output The original source includes surround Disable the surround effect settings of this --
effect sounds properly, effects, unit.
My Beam auto-adjust The listening room is too noisy. Keep the listening room as quiet as possible.
function does not work.
Try manual-adjust function.
The remote control flmctions within a
maximum range of 6 m (20 ft) and no more
than 30 degrees off-axis from the front
panel.
Select My Beam and then try again.
The remote control may be operated outside
of the remote control operation range.
53
27
52
The function does not work properly
because of the condition of the connected
components.
83 En