Manual

DE_T_7/.3F_ET_T_tiEz
• Remote control
See
Cause Remedy
page
Wrong distance or angle. 27
Problem
The remote control does not
work and/or function
properly.
Cannot operate external
components with the remote
control of this unit.
The remote control fimctions within a
maximum range of 6 m (20 ft) and no more
than 30 degrees off-axis from the front
panel.
Direct sunlight or lighting (from an inverter Reposition this unit.
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The batteries are weak. Replace all batteries.
The external component you want to operate
is not selected as the input source.
The remote control code was not correctly
set.
Even if the remote control code is correctly
set, there are some models that do not
respond to the remote control.
Press INPUT on the front panel or the input
selector buttons on the remote control to
select the external component you want to
operate.
Set the remote control code correctly or try
another code for the same manufacturer
using the "List of remote control codes" at
the end of this manual.
Use the remote control supplied with the
external component.
27
42
76
The cursor buttons de not The operation mode selector was Set the operation mode selector to YSP. --
work during SET MENU unwantedly set to TV/AV.
operation.
Cannot use the My Beam Wrong distance or angle. The remote control functions within a 52
auto-adjust function, maximum range of 6 m (20 ft) and no more
than 30 degrees off-axis from the front
panel.
• HDMI
See
Error message Cause Remedy
page
Device Error The number of the connected HDMI Reduce the number of the connected HDMI --
components exceeds the limit, components.
HDCP Error HDCP authentication failed. Check that the connected HDMI --
components support the HDCP copy
protection standards.
84 sn