Owner`s manual

75 En
Adjusting the system parameters
ADVANCED
OPERATION
English
7 Press STANDBY/ON on the remote control to
set this unit to the standby mode.
The new setting will be activated when you turn on the
power of this unit next time.
y
When the demo mode is turned on, restart the unit, then press
ENTER while playing back sources to test the sound beam.
The sound beam being output shuttles between left and right.
Press ENTER again to stop shuttling.
Parameter to be changed and front panel display Parameter settings
MEMORY PROTECT
You can protect the settings you saved in the system memory of this unit from being
accidentally erased or unwantedly changed.
ON, OFF
MAX VOLUME
You can set the maximum volume level so that this unit will not output sound beyond the
limited volume level.
MAX, 99 to 01, MIN
Control step: 1
TURN ON VOLUME
You can set the initial volume level when the power of this unit is turned on.
MAX, 99 to 01, OFF
Control step: 1
DEMO MODE
You can test the sound beam output from this unit to experience the sound beam.
ON, OFF
PANEL INP. KEY
You can disable the INPUT on the front panel when you adjust the system parameters.
ON, OFF
F.PANEL KEY
You can disable the front panel keys except when you adjust the system parameters.
ON, OFF
FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure
completely resets ALL the parameters in SET MENU.
After performing the following procedure you must run AUTO SETUP again to match your surround
sound environment.
RESET, CANCEL
MEMORYX PROTECT
MAXX VOLUMEX SET
TURNX ONX VOLUME
DEMOX MODE
PANELX INP.X KEY
F.PANELX KEY
Note
FACTORYX PRESET
STANDBY/ON