UB YST-SW015 Subwoofer System OWNER’S MANUAL YST-SW015(UB)-PRE-c 1 03.2.
IMPORTANT SAFETY INSTRUCTIONS 1 Read these instructions. CAUTION 2 Keep these instructions. RISK OF ELECTRIC SHOCK DO NOT OPEN 3 Heed all warnings. 4 Follow all instructions. 5 Do not use this apparatus near water. 6 Clean only with dry cloth. 7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
FCC INFORMATION (for US customers only) 1. 2. 3. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. IMPORTANT : When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used.
UNPACKING Please check to make sure all listed items are included. Nonskid pads For U.K. customers If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an appropriate 3 pin plug fitted. For details, refer to the instructions described below. Note: The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if engaged in a live socket outlet.
English Thank you for selecting this YAMAHA Subwoofer System. CAUTION: Read this before operating your unit. Please read the following operating precautions before use. YAMAHA will not be held responsible for any damage and/or injury caused by not following the cautions below. ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
CONTENTS IMPORTANT SAFETY INSTRUCTIONS ................................................................. II CONTROLS AND THEIR FUNCTIONS ............................................ 5 UNPACKING ........................................... IV AUTOMATIC POWER-SWITCHING FUNCTION ............................................... 6 CAUTION .................................................. 1 FEATURES ............................................... 2 ADJUSTING THE SUBWOOFER BEFORE USE ..........................
English PLACEMENT Å ı ( : subwoofer, : main speaker) It is recommended to place the subwoofer on the outside of either the right or the left main speaker. (See fig. Å .) The placement shown in fig. ı is also possible, however, if the subwoofer system is placed directly facing the wall, the bass effect may die because the sound from it and the sound reflected by the wall may cancel out each other. To prevent this from happening, face the subwoofer system at an angle as shown in fig. Å.
CONNECTIONS Caution: Plug in the subwoofer and other audio/video components after all connections are completed. Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. ● When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the DSP amplifier, be sure to connect the L/MONO INPUT terminal to the “L” side and the R INPUT terminal to the “R” side of the SPLIT SUBWOOFER terminals.
English CONTROLS AND THEIR FUNCTIONS Front panel SUBWOOFER SYSTEM YST-SW015 STANDBY/ON B.A.S.S. HIGH CUT50–150Hz VOLUME 0–10 SUBWOOFER SYSTEM YST-SW015 STANDBY/ON B.A.S.S.
7 8 9 0 POWER switch Normally, set this switch to the ON position to use the subwoofer. In this state, you can turn on the subwoofer or turn the subwoofer into the standby mode by pressing the STANDBY/ON (2) button. Set this switch to the OFF position to completely cut off the subwoofer’s power supply from the AC line. INPUT terminals Used to input line level signals from the amplifier. (Refer to “CONNECTIONS” for details.
English ADJUSTING THE SUBWOOFER BEFORE USE Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and the main speakers by following the procedures described below. Front panel SUBWOOFER SYSTEM YST-SW015 STANDBY/ON B.A.S.S. HIGH CUT50–150Hz VOLUME 0–10 SUBWOOFER SYSTEM YST-SW015 STANDBY/ON 3 B.A.S.S.
Frequency characteristics This subwoofer’s frequency characteristics 100 The figures below show the optimum adjustment of each control and the frequency characteristics when this subwoofer is combined with a typical main speaker system. EX. When combined with an 3.5” or 4” (8 cm or 10 cm) acoustic suspension, 2 way system main speakers 100 dB HIGH CUT50–150Hz VOLUME 0–10 90 PHASE–Set to the REV (reverse) position. B.A.S.S.
The theory of Yamaha Active Servo Technology has been based upon two major factors, the Helmholtz resonator and negative-impedance drive. Active Servo Processing speakers reproduce the bass frequencies through an “air woofer”, which is a port or opening in the speaker’s cabinet. This opening is used instead of, and performs the functions of, a woofer in a conventionally designed speaker system.
TROUBLESHOOTING Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions given below do not help, disconnect the power cable and contact your authorized YAMAHA dealer or service center. What to Do Cause Problem Power is not supplied even though the STANDBY/ON button is set to the ON position. The power plug is not securely connected. Connect it securely. The POWER switch is set to the OFF position.
YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND SCANDINAVIA A.