User Manual

YV3030MS Owner’s Manual • 7
Assembly
10. Attach the resonators.
Insert the resonators from underneath the main unit and
rest the high sound side and then the low sound side onto
the resonator holders.
NOTE
• Make sure not to confuse the natural tone side and acci-
dental tone side resonators.
• Take care not to bump the resonators against the legs
etc.
11. Adjust the instrument height.
Pulling the lever on the left and right leg raises the height,
while firmly pressing down on the side frame while pulling
the lever lowers the height. When you release the lever, the
instrument height is fixed at that height.
NOTE
• The legs have a scale that serves as a guide for adjust-
ing the height.
• We recommend that you lower the height slightly more
than you intend, and then make minor adjustments
while raising it little by little.
• Adjust the left and right height at the same time to main-
tain the level of the tone bars.
• Grease is applied to the cylinders of the legs to allow for
smooth height adjustment. If the grease sticks to your
hands, rinse it off with running water.
• Unbuckle the damper belt when you re-adjust the instru-
ment height.
12. Adjust the depth of the pedal pressing.
Unbuckle the damper belt, adjust the position of the pedal,
and then fix it by buckling the belt.
13. Make sure all screws are tightened securely.
Assembly is now complete.
1
2
1
2
Resonator
Holders
First, place the high sound side onto the corre-
sponding resonator holders.
To engage the low sound side, lift it over the resona-
tor holders, and then insert it into the gap between
the two holders, as shown in the illustration.
Resonator
Holders
Accidental Tone Side
Resonators
Low Sound
Side
High Sound
Side
Lever
Damper pedal
3–4 cm
Floor