User Manual

YV2030MS YT2030MS Owner’s Manual • 7
Assembly
10.Insert the resonators into the grooves of the side
frame at the treble side.
When attaching the bass side of resonators, pass the edge
of the resonators through the grooves in the middle of reso-
nator holders from below. If the temperature is 23°C or
more, use the shallow grooves A; or if the temperature is
below 23°C, use the deeper grooves B, to get optimal reso-
nance.
NOTE
• Due to the structure of the instrument, the resonators
(both natural tone and accidental tone) can only be
installed in the correct position.
11. Adjust the instrument height.
Pulling up the lever on the left and right leg raises the height
away from the floor, while pressing the instrument strongly
from above while pulling up the lever lowers it toward the
floor. When you release the lever, the instrument height is
fixed at that height.
NOTE
• The legs have a scale that serves as a guide for adjust-
ing the height.
• We recommend that you lower the height slightly more
than you intend, and then make minor adjustments
while raising it little by little.
• Adjust the left and right height at the same time to keep
the level of the tone bars.
• Grease is applied to the cylinders of the legs to change
the instrument height smoothly. If grease is sticks to
your hand, rinse it with running water.
• Unbackle the damper belt when you re-adjust the instru-
ment height.
12.Adjust the depth of the pedal pressing.
Unbuckle the damper belt, adjust the position of the pedal,
and then fix it by buckling the belt.
13.Make sure that all screws on each part are tight-
ened securely.
The assembly is now complete.
Resonators
Resonator
holder
The bass side
of the resonators
Lever
Damper pedal
3–4 cm
Floor