User Manual

YVD10 Owner’s Manual

3. Connect the driver and the con-

troller.

Connect the driver cable to the driver

connection terminal on the control-

ler. Also, align the flat shape of the

connector of the cable with the

mark printed on the controller.

* Be careful not to break the pins of the cable.

4. Set the fan belt.

First, wrap the fan belt around the

vibraphone (fan) pulley, and then

twist and hook the fan belt on the

pulley of the driver.

* Order a replacement fan belt (sold sepa-

rately) using the following number. When

ordering, please contact your dealer or quali-

fied Yamaha service personnel. Replace the

two fan belts at the same time.

The assembly is now complete.

If the distance between pulleys is too

wide to fit the belt, or if it is too nar-

row and the belt slips, first loosen the

wing nut and then adjust the tension

of the belt. After adjusting the ten-

sion, tighten the wing nut firmly.

12V

 Controller

 Driver

Cable

Part No. W5128070

Part name Fan belt

Fan belt 3ØL236

When using for a long time, the fan belt will stretch

and the pulley will run idle. If this happens, adjust

the tension of the fan belt by slightly lowering the

mounting position of the driver unit.

 Fan side

Pulley Fan belt

Fan belt Pulley Cup head square

neck bolt

 Driver side

NOTE