User Manual

9
Assembly
Controller
Driver
Screw
Arrow mark
8P DIN cable
Arrow mark
Screw
12 .
 Connectthedriverwiththecontroller.
 ConnecttheMOTORINterminalofthedriverwith
the MOTOR OUT terminalof thecontroller using
thesupplied8PDINcable*.Toconnect,alignthe
arrow mark (
)ontheplugwiththescrewnextto
thejack.
*Incasethe8PDINcableismisplaced,thefollowing
sparepartmaybeordered:
Part No. Part Name
 W5172200 8PDINCable
13 .
 Attachtheroundbelt(fanbelt)*.
 Sliptheroundbelt(fanbelt)overthefanside
pulleyrst,andthenpullitovertheangeofthe
driverpulley.
* Note For Service Personnel
 Ifthebeltcannotbemountedbecausethedis-
tancebetween the pulleys is toowide, or the
beltslips due to atoonarrow pulley distance,
loosenthe two driver positioning screws(see
illustrationtotheright)toadjustthepulley
distance(belttension).Tightenthescrewsse-
curelyafteradjustment.
*Incasethebeltismisplacedor worn, the following
sparepartmaybeordered:
Fan side
Driver side
Pulley
Roundbelt
(Fanbelt)
Driverpositioning
screws
Roundbelt
(Fanbelt)
Pulley
Part No. Part Name
 W5128041 FanBelt
02_YVRD2700_E.indd 9 2015/06/08 14:04:39