User Manual

7
Resonator
holders
x
z
Accidental tone side resonators
Treble side
Bass side
Resonator
holders
z
 First,placethetreblesideontothecorresponding
resonatorholders.
x
 Toengagethebassside,liftitovertheresonator
holdersandtheninsertitintothegapbetweenthe
twoholders,asshownintheillustration.
Assembly
7.
Attachtheinstrumenttotherack.
Position the instrument on the rack with the bolt
holes (A)locatedonthesideplate of the instru-
ment aligned with the holes (B)ontherackside
frame.
 Usingthewashers,springwashers,andknob
headbolts suppliedwith therack, attachthe in-
strumenttotherackfromtheunderside ofthe
rack(fourlocations).
8.
Attachthepedalrodtotheinstrument.
1. Loosenthecenterrodxingboltstoextendthe
centerrod.
2. Connectthecenterrodwith the fittingofthe
rodconnectorbyrmlyholdingthecenterrod
whileturningtherodconnector.
3. Tightenthe rodconnectoruntilit stops,and
thensecurewiththelocknut.
9.
 Attachtheresonators.
 Insertthe resonatorsfromunderneath the frame
and rest the treble side and then the bass side
ontotheresonatorholders(rubber).
* Make sure not to confuse the natural tone side
and accidental tone side resonators.
* Take care not to bump the resonators against
the legs etc.
Washer
Springwasher
Knob head bolt
B
Instrument
A
Rodconnector
2
Turn(screwon)
3
Secure
Locknut
Centerrodxingbolt
Centerrodxingbolt
1
Loosen
1
Loosen
Centerrod
Pedal rod
Sideplate
Sideframe
Take care not to pinch your ngers when plac-
ing the instrument onto the rack.
CAUTION
02_YVRD2700_E.indd 7 2015/06/08 14:04:37