User Manual

10
14. Pedal Stroke Adjustment
 Loosenthecenterrodxingbolts(refertopage7)
toadjusttheprotrudinglengthofthecenterrodto
the desired pedal stroke,and retightenthe bolts.
Therecommendedstroke(distancebetweenped-
alandoor)is9/16"to13/16"(1.5to2cm).
15. Tone Bar Height Adjustment
1. Loosentheslidelegxingboltswhilesupport-
ingboththebassandtreblesideframesby
hand.
2. Gasspringsintherackslideguideswillcause
theinstrument torise automatically.Afterad-
justingtheinstrumenttotherequired height,
tightenthexingboltsrmly.Usetheguideson
theslide guidesto adjustthe playingsurface
soitisparalleltotheoor.
16 .
 Afterassembly,conrmthateachboltistightened
securely.
 Then,followtheinstructionsonthenextpageand
connectthepower supplyto thecontroller power
jack(DC12-15VIN).
Never loosen the slide guide xing bolts without the
tone bars attached to the rack frame or on the legs
when not attached to the rack.
When adjusting the height of the playing surface,
make sure that adjustment is carried out by at least
two people. If a single person must unavoidably carry
out adjustment, do not move the guides any more
than 2 slide guide memory positions at a time.
Assembly
Pedal
9/16”–13/16”
(1.5–2cm)
Floor
Slideguide
xingbolt
Sideframe
Slideguide
Gasspring
(insidethelegs)
CAUTION
CAUTION
02_YVRD2700_E.indd 10 2015/06/08 14:04:40