User Manual

11
2,3
Wingnut
A
(
B
)
Center rail
C
Diagonal stay support
1
Fully insert the end of stay
C
with its notch facing up into the joint on
leg base
A
, then fi rmly tighten the wing bolt.
* Pay attention to the stay’s orientation when attaching. Parts are marked with
letters to assist with assembly. (Refer to the diagram below.)
2
Remove the wing nut, washers, and spring washers on the center rail
of the bass side leg base
A
, slide the C-shaped end of the diagonal
stay support
C
onto the bolt on the center rail then tighten the wing
nut fi rmly with washer and spring washer.
3
Use the same procedure to connect the clamp and diagonal stay
support on stay
C
to the center rail on the treble side leg base
B
.
4
Loosen the clamp screws on both ends of the rack pipe
D
and fasten
the clamps onto the poles on the upper leg section.
The rack pipe can be attached so its clamp side is either on the
audience side or the player’s side of the pole. Decide how much space
you need between the rack pipe and tone bars and attach the rack
pipe accordingly.
* Please make sure that the YAMAHA logo is not placed upside-down.
5
Firmly tighten all bolts.
Assembly of the Multi-Frame is complete.
When disassembling the multi-percussion rack, follow the
assembly steps in reverse order.
4
Tighten
Pole
D
Rack pipe
A
(
B
)
Rack frame
D
Rack pipe
1,3
C
Stay
Notch
Wing bolt
A
(
B
)
Leg base
1
4
6
6
2
4
A
Leg base
B
Leg base
D
Rack pipe
3
C
Stay
3
Spring washer
Washer
Tighten
Match “Y”
Match “Z”
※
※
Assembly
First, assemble the Multi-Frame (RD500) then attach the xylophone set (YX500FT) onto the frame.
For safety reasons, make sure that assembly of the Multi-Frame and attaching of the instrument is
carried out with two or more persons, and that you assemble the product in an area with adequate
space.
D
Rack pipe
Rack frame
Center rail