Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
4-47
ENG
YPVS GOVERNOR
2. Install:
9
Ball 1
9
Retainer 2
To governor shaft 3.
NOTE:
Apply the transmission oil on the retainer and
ball.
3. Install:
9
Dowel pin 1
NOTE:
9
While compressing the spring, install the dowel
pin.
9
Make sure the dowel pin fits into the groove a
in the retainer.
4. Install:
9
Governor assembly 1
NOTE:
Align the groove a in the governor with the fork
b and set the governor in the crankcase cover.
1C3-28199-10 136 04.5.17, 9:23:24 PM