Service manual

4-54
ENG
CDI MAGNETO
2. Install:
9
Woodruff key 1
9
Rotor 2
NOTE:
9
Clean the tapered portions of the crankshaft
and rotor.
9
When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
9
When installing the rotor, align the keyway c
of the rotor with the woodruff key.
3. Install:
9
Plain washer 1
9
Nut (rotor) 2
Use the rotor holding tool 3.
4. Adjust:
9
Ignition timing
Refer to “IGNITION TIMING CHECK” sec-
tion in the CHAPTER 3.
5. Tighten:
9
Screw (stator) 1
6. Check:
9
Ignition timing
Re-check the ignition timing.
56 Nm (5.6 m•kg, 40 ft•lb)
Rotor holding tool:
YU-1235/90890-01235
7 Nm (0.7 m•kg, 5.1 ft•lb)
Ignition timing (B.T.D.C.):
0.48 mm (0.019 in)
1C3-28199-10 143 04.5.17, 9:23:48 PM