Service manual

4-61
ENG
CRANKCASE AND CRANKSHAFT
Extent of removal Order Part name Q’ty Remarks
CRANKCASE AND CRANKSHAFT
REMOVAL
Preparation for Engine Refer to “ ENGINE REMOVAL” section.
removal Piston Refer to “
CYLINDER HEAD, CYLINDER
AND PISTON
” section.
Primary drive gear
Kick idle gear
Refer to “
KICK AXLE, SHIFT SHAFT AND
Stopper lever
PRIMARY DRIVE GEAR” section.
Rotor and stator Refer to “CDI MAGNETO” section.
1 Segment 1 Refer to “REMOVAL POINTS”.
2 Bolt [L=45 mm (1.77 in)] 6
3 Bolt [L=55 mm (2.17 in)] 4
4 Bolt [L=65 mm (2.56 in)] 1
5 Bolt [L=75 mm (2.95 in)] 1
6 Holder 1
7 Crankcase (right) 1 Use special tool.
8 Crankcase (left) 1 Refer to “REMOVAL POINTS”.
9 Crankshaft 1 Use special tool.
Refer to “REMOVAL POINTS”.
10 Oil seal 2
11 Bearing 2 Refer to “REMOVAL POINTS”.





EC4N0000
CRANKCASE AND CRANKSHAFT
1
2
3
Extent of removal: 1 Crankcase separation 2 Crankshaft removal
3 Crankshaft bearing removal



30 Nm (3.0 m•kg, 22 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
14 Nm (1.4 m•kg, 10 ft•lb)
1C3-28199-10 150 04.5.17, 9:24:10 PM