Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-5
CHAS
FRONT WHEEL AND REAR WHEEL
EC595000
ASSEMBLY AND INSTALLATION
EC595101
Front wheel
1. Install:
9
Bearing (left) 1
9
Spacer 2
9
Bearing (right) 3
9
Oil seal 4
NOTE:
9
Apply the lithium soap base grease on the
bearing and oil seal lip when installing.
9
Use a socket that matches the outside diam-
eter of the race of the bearing.
9
Left side of bearing shall be installed first.
9
Install the oil seal with its manufacture’s
marks or numbers facing outward.
cC
Do not strike the inner race of the bearing.
Contact should be made only with the out-
er race.
2. Install:
9
Brake disc 1
9
Bolt (brake disc) 2
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
3. Install:
9
Collar 1
NOTE:
9
Apply the lithium soap base grease on the oil
seal lip.
9
Install the collars with their projections a facing
the wheel.
4. Install:
9
Wheel
NOTE:
Install the brake disc 1 between the brake pads
2 correctly.
12 Nm (1.2 m•kg, 8.7 ft•lb)
1C3-28199-10 168 04.5.17, 9:25:19 PM