Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-8
CHAS
FRONT WHEEL AND REAR WHEEL
3. Install:
9
Driven sprocket 1
9
Bolt (driven sprocket) 2
9
Plain washer (driven sprocket) 3
9
Nut (driven sprocket) 4
NOTE:
Tighten the nuts in stage, using a crisscross pat-
tern.
4. Install:
9
Collar 1
NOTE:
Apply the lithium soap base grease on the oil
seal lip.
5. Install:
9
Wheel
NOTE:
Install the brake disc 1 between the brake pads
2 correctly.
6. Install:
9
Drive chain 1
NOTE:
Push the wheel 2 forward and install the drive
chain.
7. Install:
9
Chain puller (left) 1
9
Wheel axle 2
NOTE:
9
Install the chain puller (left), and insert the
wheel axle from left side.
9
Apply the lithium soap base grease on the
wheel axle.
42 Nm (4.2 m•kg, 30 ft•lb)
1C3-28199-10 171 04.5.17, 9:25:30 PM