Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-18
CHAS
FRONT BRAKE AND REAR BRAKE
EC5A5121
Rear caliper
1. Install:
9
Pad support 1
9
Brake pad 2
9
Pad pin 3
NOTE:
9
Install the brake pads with their projections
a into the caliper recesses b.
9
Temporarily tighten the pad pin at this point.
2. Install:
9
Disc cover 1
9
Bolt (disc cover) 2
2. Install:
9
Caliper 1
9
Bolt (caliper) 2
3. Tighten:
9
Pad pin 3
4. Install:
9
Pad pin plug 4
23 Nm (2.3 m•kg, 17 ft•lb)
18 Nm (1.8 m•kg, 13 ft•lb)
3 Nm (0.3 m•kg, 2.2 ft•lb)
7 Nm (0.7 m•kg, 5.1 ft•lb)
18 Nm (1.8 m•kg, 13 ft•lb)
3 Nm (0.3 m•kg, 2.2 ft•lb)
3. Install:
9
Caliper 1
9
Rear wheel 2
Refer to “FRONT WHEEL AND REAR
WHEEL” section.
4. Tighten:
9
Pad pin 3
5. Install:
9
Pad pin plug 4
1C3-28199-10 181 04.5.17, 9:26:12 PM