Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
![](/manual/yamaha/yz125t1/service-manual-english/images/img-185.png)
5-22
CHAS
FRONT BRAKE AND REAR BRAKE
2. Install:
9
Brake hose holder 1
9
Bolt (brake hose holder) 2
3. Install:
9
Brake hose holder 1
9
Nut (brake hose holder) 2
NOTE:
Align the top a of the brake hose holder with
the paint b of the brake hose.
10 Nm (1.0 m•kg, 7.2 ft•lb)
7 Nm (0.7 m•kg, 5.1 ft•lb)
4. Install:
9
Pin 1
9
Plain washer 2
9
Cotter pin 3
NOTE:
After installing, check the brake pedal height.
Refer to “REAR BRAKE ADJUSTMENT” section
in the CHAPTER 3.
EC5A5911
Front brake hose
1. Install:
9
Copper washer 1
9
Brake hose 2
9
Union bolt 3
w
Always use new copper washers.
cC
Install the brake hose so that its pipe por-
tion
a
directs as shown and lightly touch-
es the projection
b
on the caliper.
30 Nm (3.0 m•kg, 22 ft•lb)
1C3-28199-10 185 04.5.17, 9:26:30 PM