Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-29
CHAS
FRONT FORK
Adjuster
1. Drain the outer tube of its front fork oil at its
top.
2. Loosen:
9
Adjuster 1
3. Remove:
9
Adjuster 1
NOTE:
9 While compressing the inner tube 2 , set the
cap bolt ring wrench 4 between the inner tube
and locknut 3 .
9 Hold the locknut and remove the adjuster.
cC
Do not remove the locknut as it may go
into the damper assembly and not be taken
out.
Cap bolt ring wrench:
YM-01501/90890-01501
EC553201
Inner tube
1. Remove:
9
Dust seal 1
9
Stopper ring 2
Using slotted-head screwdriver.
cC
Take care not to scratch the inner tube.
2. Remove:
9
Inner tube 1
Oil seal removal steps:
9
Push in slowly a the inner tube just be-
fore it bottoms out and then pull it back
quickly b.
9
Repeat this step until the inner tube can
be pulled out from the outer tube.
1C3-28199-10 192 04.5.17, 9:27:00 PM