Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-37
CHAS
FRONT FORK
21. Check:
9
Inner tube smooth movement
Tightness/Binding/Rough spots → Repeat the
steps 14 to 20.
22. Measure:
9
Distance a
Out of specification→Turn into the locknut.
Distance
aa
:
19 mm (0.75 in) or more
Between damper assembly
1
bottom and locknut
2
bottom.
23. Install:
9
Spacer (metal) 1
9
Fork spring 2
9
Spacer (resin) 3
To damper assembly 4.
NOTE:
Install the spacer with the plate a facing the fork
spring.
24. Install:
9
Damper assembly 1
To inner tube 2.
cC
To install the damper assembly into the
inner tube, hold the inner tube aslant. If the
inner tube is held vertically, the damper
assembly may fall into it, damaging the
valve inside.
25 Loosen:
9
Rebound damping adjuster 1
NOTE:
9
Loosen the rebound damping adjuster finger
tight.
9
Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
1C3-28199-10 200 04.5.17, 9:27:37 PM