Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-39
CHAS
FRONT FORK
31. Install:
9
Damper assembly 1
To outer tube.
NOTE:
Temporarily tighten the damper assembly.
32. Install:
9
Protector guide 1
EC5552A1
Installation
1. Install:
9
Front fork 1
NOTE:
9
Temporarily tighten the pinch bolts (under
bracket).
9
Do not tighten the pinch bolts (handle crown)
yet.
2. Tighten:
9
Damper assembly 1
NOTE:
Use the cap bolt ring wrench 2 to tighten the
damper assembly with specified torque.
w
Never fail to make the oil amount adjustment
between the maximum and minimum
amount and always adjust each front fork to
the same setting. Uneven adjustment can
cause poor handling and loss of stability.
cC
9
Be sure to use recommended fork oil. If
other oils are used, they may have an ex-
cessively adverse effect on the front fork
performance.
9
Never allow foreign materials to enter the
front fork.
30 Nm (3.0 m•kg, 22 ft•lb)
Cap bolt ring wrench:
YM-01501/90890-01501
1C3-28199-10 202 04.5.17, 9:27:47 PM