Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
![](/manual/yamaha/yz125t1/service-manual-english/images/img-203.png)
5-40
CHAS
FRONT FORK
6. Adjust:
9
Rebound damping force
NOTE:
Turn in the damping adjuster 1 finger-tight and
then turn out to the originally set position.
5. Install:
9
Protector 1
9
Bolt (protector) 2
10 Nm (1.0 m•kg, 7.2 ft•lb)
3. Adjust:
9
Front fork top end a
Front fork top end (standard)
a
:
5 mm (0.20 in)
4. Tighten:
9
Pinch bolt (handle crown) 1
9
Pinch bolt (under bracket) 2
cC
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
23 Nm (2.3 m•kg, 17 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
7. Adjust:
9
Compression damping force
NOTE:
Turn in the damping adjuster 1 finger-tight and
then turn out to the originally set position.
1C3-28199-10 203 04.5.17, 9:27:51 PM