Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-44
CHAS
HANDLEBAR
2. Install:
9
Grip cap (upper) 1
9
Grip cap (lower) 2
9
Bolt (grip cap) 3
NOTE:
Temporarily tighten the bolts (grip cap).
EC5B5210
Handlebar
1. Install:
9
Handlebar 1
9
Handlebar holder 2
9
Bolt (handlebar holder) 3
NOTE:
9
The upper handlebar holder should be installed
with the punched mark a forward.
9
Install the handlebar so that the marks b are in
place on both sides.
9
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts on
the rear side.
2. Install:
9
Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
9
Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
9
Install the grip (left) to the handlebar so that the
line b between the two arrow marks faces
straight upward.
28 Nm (2.8 m•kg, 20 ft•lb)
1C3-28199-10 207 04.5.17, 9:28:08 PM