Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-45
CHAS
HANDLEBAR
4. Install:
9
Throttle cable 1
To tube guide 2.
NOTE:
Apply the lithium soap base grease on the throt-
tle cable end and tube guide cable winding por-
tion.
5. Install:
9
Roller 1
9
Collar 2
NOTE:
9
Apply the lithium soap base grease on the
roller sliding surface.
9
Install the roller so that the “UPPER” mark a
faces upward.
9
Pass the throttle cable in the groove b in the
roller.
6. Install:
9
Throttle cable cap 1
9
Screw (throttle cable cap) 2
7. Adjust:
9
Throttle grip free play
Refer to ”THROTTLE CABLE ADJUST-
MENT” section in the CHAPTER 3.
8. Install:
9
Cap cover 1
1 Nm (0.1 m•kg, 0.7 ft•lb)
3. Install:
9
Collar 1
9
Cap cover 2
9
Throttle 3
NOTE:
9
Apply the lithium soap base grease on the
throttle grip sliding surface.
9
Tighten the grip cap bolts temporarily without the
throttle being fixed to the handlebar.
1C3-28199-10 208 04.5.17, 9:28:13 PM