Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-52
CHAS
STEERING
11. Adjust:
9
Front fork top end a
12. Tighten:
9
Pinch bolt (handle crown) 1
9
Pinch bolt (under bracket) 2
cC
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
Front fork top end (standard)
a
:
5 mm (0.20 in)
23 Nm (2.3 m•kg, 17 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
9. Install:
9
Steering shaft cap 1
10. After tightening the nut, check the steering for
smooth movement. If not, adjust the steering
by loosening the ring nut little by little.
1C3-28199-10 215 04.5.17, 9:28:45 PM