Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-56
CHAS
SWINGARM
EC575000
ASSEMBLY AND INSTALLATION
EC575202
Bearing and oil seal
1. Install:
9
Bearing 1
9
Oil seal 2
To swingarm.
NOTE:
9
Apply the molybdenum disulfide grease on the
bearing when installing.
9
Install the bearing by pressing it on the side hav-
ing the manufacture's marks or numbers.
9
First install the outer and then the inner bear-
ings to a specified depth from inside.
Installed depth of bearings:
Outer
a
: Zero mm (Zero in)
Inner
b
: 8.5 mm (0.33 in)
EC574311
Connecting rod
1. Inspect:
9
Bearing 1
9
Collar 2
Free play exists/Unsmooth revolution/Rust →
Replace bearing and collar as a set.
2. Inspect:
9
Oil seal 3
Damage → Replace.
2. Install:
9
Bearing 1
9
Plain washer 2
9
Oil seal 3
To relay arm.
NOTE:
9
Apply the molybdenum disulfide grease on the
bearing when installing.
9
Install the bearing by pressing it on the side hav-
ing the manufacture's marks or numbers.
9
Apply the molybdenum disulfide grease on the
plain washer.
Installed depth of bearings
a
:
Zero mm (Zero in)
1C3-28199-10 219 04.5.17, 9:29:03 PM