Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-58
CHAS
SWINGARM
5. Install:
9
Relay arm 1
9
Bolt (relay arm) 2
9
Plain washer 3
9
Nut (relay arm) 4
To swingarm.
NOTE:
9
Apply the molybdenum disulfide grease on the
bolt.
9
Do not tighten the nut yet.
6. Install:
9
Swingarm 1
9
Pivot shaft 2
NOTE:
9
Apply the molybdenum disulfide grease on the
pivot shaft.
9
Insert the pivot shaft from right side.
85 Nm (8.5 m•kg, 61 ft•lb)
4. Install:
9
Connecting rod 1
9
Bolt (connecting rod) 2
9
Plain washer 3
9
Nut (connecting rod) 4
To relay arm 5.
NOTE:
Apply the molybdenum disulfide grease on the
bolt.
80 Nm (8.0 m•kg, 58 ft•lb)
7. Check:
9
Swingarm side play a
Free play exists → Replace thrust bearing.
9
Swingarm up and down movement b
Unsmooth movement/Binding/Rough
spots→Grease or replace bearings, bushes
and collars.
1C3-28199-10 221 04.5.17, 9:29:13 PM