Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
5-65
CHAS
REAR SHOCK ABSORBER
EC5852B5
Rear shock absorber
1. Install:
9
Dust seal 1
9
O-ring 2
9
Collar 3
NOTE:
9 Apply the molybdenum disulfide grease on the
bearing.
9 Apply the lithium soap base grease on the dust
seals, O-rings and collars.
2. Install:
9
Bush 1
9
Collar 2
9
Dust seal 3
NOTE:
9 Apply the molybdenum disulfide grease on the
bearing.
9 Apply the lithium soap base grease on the
bush, collars and dust seals.
9 Install the dust seals with their lips facing out-
ward.
3. Adjust:
9
Spring length (installed) a
*For EUROPE
NOTE:
The length of the spring (installed) changes 1.5
mm (0.06 in) per turn of the adjuster.
cC
Never attempt to turn the adjuster beyond
the maximum or minimum setting.
4. Tighten:
9
Locknut 1
Spring length (installed)
a
:
Standard
length
252 mm (9.92 in)
*248 mm (9.76 in)
Extent of
adjustment
240.5~258.5 mm
(9.47~10.18 in)
1C3-28199-10 228 04.5.17, 9:29:46 PM