Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
6
6-2
ELEC
IGNITION SYSTEM
EC620000
IGNITION SYSTEM
EC621003
INSPECTION STEPS
Use the following steps for checking the possibility of the malfunctioning engine being attributable to
ignition system failure and for checking the spark plug which will not spark.
*Clean or replace
spark plug.
Primary coil
Secondary coil
Repair or replace.
Spark
Check entire ignition
system for connection.
Spark gap test
No good
No good
No good
No good
No good
No good
No Spark
Check “ENGINE STOP”
button.
Pick-up coil
Source coil
Check ignition coil.
Check CDI magneto.
Replace CDI unit.
Replace.
Replace.
Replace.
Replace.
Replace.
*marked: Only when the ignition checker is used.
NOTE:
9
Remove the following parts before inspection.
1) Seat
2) Fuel tank
9
Use the following special tools in this inspection.
Dynamic spark tester:
YM-34487
Ignition checker:
90890-06754
Pocket tester:
YU-3112-C/90890-03112
OK
OK
OK
OK
Replace.
Check spark plug cap.
No good
OK
1C3-28199-10 231 04.5.17, 9:29:59 PM