Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
7-7
TUN
SETTING
EC71B040
Relationship with throttle opening
The flow of the fuel through the carburetor main
system is controlled by the main jet and then, it is
further regulated by the area between the main
nozzle and the jet needle. On the relationship
between the fuel flow and the throttle opening,
the fuel flow relates to the straight portion of the
jet needle at full closed~1/8 throttle, to the 1st
tapered portion at 1/4 throttle, to the second
tapered portion at 1/2 throttle, to the third tapered
portion at 3/4 throttle and to the fourth tapered
portion at full open.
Therefore, the fuel flow is balanced at each stage
of throttle opening by a combination of the jet
needle diameter and clip position.
<Example>
6CHY5-80-4th groove
6CHY5-80-3rd groove
6CHY5-81-4th groove
å Lean (larger diameter)
∫ Rich (smaller diameter)
1 Full closed
2 1/4 throttle
3 1/2 throttle
4 3/4 throttle
5 Full open
1st taper
2nd taper
3rd taper
4th taper
a Main nozzle
IV
III
II
I
1C3-28199-10 242 04.5.17, 9:30:49 PM