Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
2-15
SPEC
CABLE ROUTING DIAGRAM
1 “ENGINE STOP” button lead
2 C.D.I. magneto lead
3 Ignition coil lead
4 Ground lead
5 Positioning tape
6 Protection tube
7 C.D.I.unit
8 Throttle cable
9 Clutch cable
0 Side core
q Radiator breather hose
A Pass the high tension cord to
the left of the radiator hose.
B Clamp to the frame the
“ENGINE STOP” button lead
and C.D.I. magneto lead.
Clamp them in front of the radi-
ator fitting boss.
C Clamp to the frame the throttle
cable, clutch cable and ignition
coil lead.
D Pass the C.D.I. magneto lead
and radiator breather hose
between the frame and the
right side of the radiator.
E Insert the C.D.I. unit band until
it stops at the C.D.I. unit stay.
F Pass the C.D.I. magneto lead
and radiator breather hose
between the frame and the
radiator hose.
G Locate the clamp ends in the
arrowed range.
1C3-28199-10 47 04.6.16, 2:07:06 PM