Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
2-16
SPEC
CABLE ROUTING DIAGRAM
A Install the brake hose so that its pipe portion
directs as shown and lightly touches the projec-
tion on the caliper.
B Pass the brake hose into the brake hose
holders.
C If the brake hose contacts the spring (rear
shock absorber), correct its twist.
D Install the brake hose so that its pipe portion
directs as shown and lightly touches the
projection on the master cylinder.
1 Master cylinder
2 Brake hose holder
3 Brake hose
1C3-28199-10 48 04.5.17, 9:19:50 PM