Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
2-17
SPEC
CABLE ROUTING DIAGRAM
A Install the brake hose so that its pipe portion
directs as shown and lightly touches the
projection on the master cylinder.
B Pass the “ENGINE STOP” button lead in
the middle of the clutch holder.
C Clamp the “ENGINE STOP” button lead to
the handlebar to 3 clicks.
D Pass the brake hose in front of the number
plate and through the cable guide.
1 Brake hose
2 Master cylinder
3 “ENGINE STOP” button lead
4 “ENGINE STOP” button
5 Throttle cable
6 Clutch cable
7 Clamp
8 Cable guide
1C3-28199-10 49 04.5.17, 9:19:52 PM