Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
3-10
INSP
ADJ
THROTTLE CABLE ADJUSTMENT/
THROTTLE LUBRICATION
EC35A001
THROTTLE CABLE ADJUSTMENT
1. Check:
9
Throttle grip free play a
Out of specification→Adjust.
2. Adjust:
9
Throttle grip free play
EC35S002
THROTTLE LUBRICATION
1. Remove:
9
Cap cover 1
9
Throttle cable cap 2
Throttle grip free play adjustment steps:
9
Loosen the locknut 1.
9
Turn the adjuster 2 until the specified free
play is obtained.
9
Tighten the locknut.
NOTE:
Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
w
After adjusting, turn the handlebar to
right and left and make sure that the en-
gine idling does not run faster.
Throttle grip free play
a
:
3~5 mm (0.12~0.20 in)
Locknut:
7 Nm (0.7 m•kg, 5.1 ft•lb)
2. Apply:
9
Lithium soap base grease
On the throttle cable end a, tube guide ca-
ble winding portion b and roller sliding
surface c.
1C3-28199-10 59 04.5.17, 9:20:08 PM