Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
3-23
REAR BRAKE PAD INSULATOR INSPECTION
BRAKE FLUID LEVEL INSPECTION
INSP
ADJ
EC36b000
REAR BRAKE PAD INSULATOR
INSPECTION
1. Remove:
9
Brake pad
Refer to
“
REAR BRAKE PAD INSPEC-
TION AND REPLACEMENT” section.
2. Inspect:
9
Rear brake pad insulator 1
Damage → Replace.
EC367001
BRAKE FLUID LEVEL INSPECTION
1. Place the master cylinder so that its top is in
a horizontal position.
2. Inspect:
9
Brake fluid level
Fluid at lower level → Fill up.
a Lower level
ÅFront
ıRear
w
9
Use only designated quality brake fluid to
avoid poor brake performance.
9
Refill with same type and brand of brake flu-
id; mixing fluids could result in poor brake
performance.
9
Be sure that water or other contaminants do
not enter master cylinder when refilling.
9
Clean up spilled fluid immediately to avoid
erosion of painted surfaces or plastic parts.
Recommended brake fluid:
DOT #4
1C3-28199-10 72 04.5.17, 9:20:36 PM