Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
3-32
REAR SHOCK ABSORBER LOW COMPRESSION
DAMPING FORCE ADJUSTMENT
INSP
ADJ
EC36c000
REAR SHOCK ABSORBER LOW
COMPRESSION DAMPING FORCE
ADJUSTMENT
1. Adjust:
9
Low compression damping force
By turning the adjuster 1.
9
STANDARD POSITION:
This is the position which is back by the specif-
ic number of clicks from the fully turned-in posi-
tion. (Which align the punch mark a on the ad-
juster with the punch mark b on the high com-
pression damping adjuster.)
cC
Do not force the adjuster past the mini-
mum or maximum extent of adjustment.
The adjuster may be damaged.
Stiffer
a
→ Increase the low compression
damping force. (Turn the ad-
juster
1
in.)
Softer
b
→ Decrease the low compres-
sion damping force. (Turn
the adjuster
1
out.)
Minimum
20 clicks out
(from maximum
position)
Extent of adjustment:
Maximum
Fully turned in
position
Standard position:
About 13 clicks out
*About 11 clicks out
*For EUROPE
1C3-28199-10 81 04.5.17, 9:20:57 PM