Service manual

3-36
STEERING HEAD INSPECTION AND ADJUSTMENT
INSP
ADJ
9
Loosen the ring nut one turn.
9
Retighten the ring nut using the ring nut
wrench.
w
Avoid over-tightening.
9
Check the steering shaft by turning it lock to
lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
9
Install the plain washer 5, handle crown 6,
plain washer 7, steering shaft nut 8, steer-
ing shaft cap 9, handlebar 0, handlebar
holder q and number plate w.
NOTE:
9
The upper handlebar holder should be
installed with the punched mark a forward.
9
Install the handlebar so that the marks b
are in place on both sides.
9
Insert the end of the fuel breather hose e
into the hole in the steering shaft cap.
cC
First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
Ring nut wrench:
YU-33975/90890-01403
Ring nut (initial tightening):
38 Nm (3.8 m•kg, 27ft•lb)
Steering shaft nut:
145 Nm (14.5 m•kg, 105 t•lb)
Handlebar upper holder:
28 Nm (2.8 m•kg, 20 ft•lb)
Pinch bolt (handle crown):
23 Nm (2.3 m•kg, 17 ft•lb)
Number plate:
7 Nm (0.7 m•kg, 5.1 ft•lb)
Ring nut (final tightening):
7 Nm (0.7 m•kg, 5.1 ft•lb)
1C3-28199-10 85 04.5.17, 9:21:07 PM