Service manual
Table Of Contents
- Inroduction
- Yamaha Motor Corporation, USA YZ/WR Motorcycle Limited Warranty
- How to use this Manual
- Index
- Contents
- Chapter 1 General Information
- Chapter 2 Specifications
- Chapter 3 Regular Inspection and Adjustments
- Chapter 4 Engine
- Seat, Fuel Tank and Side Covers
- Exhaust Pipe and Silencer
- Radiator
- Carburetor and Reed Valve
- Cylinder Head, Cylinder and Piston
- Clutch and Primary Driven Gear
- Kick Axle, Shift Shaft and Primary Drive Gear
- YPVS Govenor
- Water Pump
- CDI Magneto
- Engine Removal
- Crankcase and Crankshaft
- Transmission, Shift Cam and Shift Fork
- Chapter 5 Chassis
- Chapter 6 Electrical
- Chapter 7 Tuning
4-9
ENG
CARBURETOR AND REED VALVE
EC466030
HANDLING NOTE
cC
Do not disassemble the venturi block
1
and main nozzle
2
because it will cause a
drop in carburetor performance.
EC463000
REMOVAL POINTS
EC463110
Throttle valve
1. Remove:
9
Throttle valve 1
9
Ring 2
9
Spring (throttle valve) 3
9
Mixing chamber top 4
9
Throttle cable 5
NOTE:
While compressing the spring (throttle valve),
disconnect the throttle cable.
EC464000
INSPECTION
EC464140
Carburetor
1. Inspect:
9
Carburetor body
Contamination → Clean.
cC
When cleaning the main air passage
a
, do
not blow air at the filter side because it will
clog the passage with mud or sand.
NOTE:
9
Use a petroleum based solvent for cleaning.
Blow out all passages and jets with com-
pressed air.
9
Never use a wire.
9
When cleaning the main air passage, blow air
through it while covering the nozzle with a
clean rag.
1C3-28199-10 98 04.5.17, 9:21:39 PM