Service manual

4-65
CRANKCASE AND CRANKSHAFT
ENG
Extent of removal Order Part name Q’ty Remarks
CRANKCASE AND CRANKSHAFT
REMOVAL
Preparation for Engine Refer to “ ENGINE REMOVAL” section.
removal Piston Refer to “
CYLINDER HEAD, CYLINDER
AND PISTON
” section.
Primary drive gear
Kick idle gear
Refer to “
KICK AXLE, SHIFT SHAFT AND
Stopper lever
PRIMARY DRIVE GEAR” section.
Rotor and stator Refer to “CDI MAGNETO” section.
1 Segment 1
2 Bolt [L=50 mm (1.97 in)] 7
3 Bolt [L=60 mm (2.36 in)] 1
4 Bolt [L=70 mm (2.76 in)] 3
5 Holder 2
6 Crankcase (right) 1 Use special tool.
7 Crankcase (left) 1 Refer to “REMOVAL POINTS”.
8 Crankshaft 1 Use special tool.
Refer to “REMOVAL POINTS”.
9 Oil seal 2
10 Bearing 2 Refer to “REMOVAL POINTS”.





EC4N0000
CRANKCASE AND CRANKSHAFT
1
2
3
Extent of removal: 1 Crankcase separation 2 Crankshaft removal
3 Crankshaft bearing removal



10 Nm (1.0 m•kg, 7.2 ft•lb)
30 Nm (3.0 m•kg, 22 ft•lb)
14 Nm (1.4 m•kg, 10 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
1P8-28199-10 155 04.5.12, 7:45:16 PM