Service manual

4-71
CRANKCASE AND CRANKSHAFT
ENG
8. Tighten:
9
Segment 1
9
Bolt (segment) 2
NOTE:
9
When installing the segment onto the shift cam
3, align the punch mark a with the dowel pin
b.
9
Turn the segment clockwise until it stops and
tighten the bolt.
30 Nm (3.0 m•kg, 22 ft•lb)
7. Install:
9
Tension spring 1
9
Holder 2
9
Bolt (holder) 3
NOTE:
Install the holder so that it contacts the projec-
tion a on the crankcase (right).
10 Nm (1.0 m•kg, 7.2 ft•lb)
9. Remove:
9
Sealant
Forced out on the cylinder mating surface.
10. Apply:
9
Engine oil
To the crank pin, bearing, oil delivery hole
and connecting rod big end washer.
11. Check:
9
Crankshaft and transmission operation
Unsmooth operation
→ Repair.
14 Nm (1.4 m•kg, 10 ft•lb)
6. Install:
9
Bolt (crankcase) 1
NOTE:
Tighten the crankcase tightening bolts in stage,
using a crisscross pattern.
1P8-28199-10 161 04.5.12, 7:45:40 PM