Service manual

CHAS
4-28
N
O
TE:N
O
TE:
While holding the brake hose, tighten the
union bolt as shown.
Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables, leads).
Correct if necessary.
3. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
WARNING
Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
Refill with the same type of brake fluid that
is already in the system. Mixing brake flu-
ids may result in a harmful chemical reac-
tion, leading to poor brake performance.
When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the boil-
ing point of the brake fluid and could
cause vapor lock.
CAUTION:
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
4. Bleed:
• brake system
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM” in chapter 3.
5. Check:
• brake fluid level
Below the minimum level mark Add
the recommended brake fluid to the proper
level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL” in chapter 3.
Recommended brake fluid
DOT 4
FRONT AND REAR BRAKES