Service manual

CHAS
4-58
N
O
TE:N
O
TE:
• The upper handlebar holders should be
installed with the punched mark forward.
• First tighten the bolts on the front side of the
handlebar upper holder, and then tighten the
bolts on the rear side.
3. Install:
• left grip
• apply the adhesive to the handlebar .
N
O
TE:N
O
TE:
• Before applying the adhesive, wipe off grease
or oil on the handlebar surface with a lac-
quer thinner.
• Install the left grip to the handlebar so that the
arrow mark (L) faces straight upward.
4. Install:
• right grip
• apply the adhesive on the tube guide .
N
O
TE:N
O
TE:
• Before applying the adhesive, wipe off grease
or oil on the tube guide surface with a lac-
quer thinner.
• Locate the mating mark on the grip as
shown.
5. Install:
•collar
• tube guide
• grip cap (upper)
• throttle cable
N
O
TE:N
O
TE:
Apply the lithium soap base grease on the
throttle cable end and tube guide cable wind-
ing portion.
FWD
HANDLEBAR