Service manual

ENG
5-45
2. Install:
• dowel pin
• right crankcase
(onto the left crankcase )
N
O
TE:N
O
TE:
• Turn the shift cam to the position shown in
the figure so that it does not contact the
crankcase when installing the crankcase.
• Fit the right crankcase onto the left crank-
case. Tap lightly on the case with soft ham-
mer.
• When installing the crankcase, the connect-
ing rod should be positioned at TDC.
3. Install:
•clamp
•screw
N
O
TE:N
O
TE:
Tighten the crankcase tightening screws in
stage, using a crisscross pattern.
4. Install:
• crankcase oil seal holder
•bolt
LOCTITE
®
5. Remove:
• sealant
• forced out on the cylinder mating surface.
6. Apply:
• Transmission oil
To the crank pin, bearing, oil delivery hole
and connecting rod end washer.
7. Check:
• crankshaft and transmission operation
Unsmooth operation → Repair.
8 Nm (0.8 m•kg, 5.8 ft•lb)
20 Nm (2.0 m•kg, 14 ft•lb)
CRANKCASE AND CRANKSHAFT