Service manual

CHAS
4-19
8. Check:
• brake lever operation
Soft or spongy feeling → Bleed the brake
system.
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM” in chapter 3.
EAS00583
REPLACING THE REAR BRAKE PADS
N
O
TE:N
O
TE:
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disas-
semble the brake caliper.
1. Loosen:
• brake pad pins
2. Remove:
• brake caliper
3. Remove:
• brake pad pins
• brake pads
(along with the brake pad shims)
• brake pad spring
4. Measure:
• brake pad wear limit
Out of specification → Replace the brake
pads as a set.
5. Install:
• brake pad spring
• brake pad shims
(onto the brake pads)
• brake pads
• brake pad pins
• brake caliper
N
O
TE:N
O
TE:
Always install new brake pads, brake pad
shims, and a brake pad spring as a set.
Brake pad wear limit
1.0 mm (0.04 in)
FRONT AND REAR BRAKES