Owner`s manual

INSTRUMENT AND CONTROL FUNCTIONS
4-6
4
The multi-function meter unit is
equipped with the following:
● a speedometer
● a tachometer
● an odometer
● two tripmeters (which show the
distance traveled since they were
last set to zero)
● a fuel reserve tripmeter (which
shows the distance traveled since
the fuel level warning light came
on)
● a stopwatch
● a clock
● a coolant temperature display
● an air intake temperature display
● a self-diagnosis device
● a display brightness and shift tim-
ing indicator light control mode
TIP
● Be sure to turn the key to “ON” be-
fore using the “SELECT” and “RE-
SET” buttons, except for setting
the display brightness and shift
timing indicator light control mode.
● To switch the speedometer and
odometer/tripmeter displays be-
tween kilometers and miles, press
the “SELECT” button for at least
one second.
Tachometer
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to “ON”, the ta-
chometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electri-
cal circuit.
NOTICE
ECA10031
Do not operate the engine in the ta-
chometer red zone.
Red zone: 16500 r/min and above
Clock
To set the clock
1. Turn the key to “ON”.
2. Push the “SELECT” button and
“RESET” button together for at
least two seconds.
3. When the hour digits start flashing,
push the “RESET” button to set the
hours.
4. Push the “SELECT” button, and
the minute digits will start flashing.
1. Tachometer
2. Tachometer red zone
2
1
1. Clock
TRIP A
MPH
1
U13S12E0.book Page 6 Tuesday, September 15, 2009 1:52 PM