User Manual

Audio settings for livestreaming
Configure the livestreaming audio settings and set the output destination for the livestreaming audio in the
“STREAMING OUTPUT MIXER” screen of “Yamaha ZG Controller”.
1 Launch the Yamaha ZG Controller app.
2 Open the “STREAMING OUTPUT MIXER” screen.
3 Set each of the INPUT parameters.
Adjust the volume for MIC (microphone audio), VOICE (voice chat audio) and GAME (game
audio). The audio signals you adjust here are output as livestreaming audio. Effects can be
turned on/off as well for VOICE and GAME.
4 Set each of the OUTPUT parameters.
Set the output destination for the livestreaming audio. When USB is ON, the audio is sent to
the [USB] port; and when HDMI is ON the audio is sent to the [HDMI OUT] connector. Both
destinations can be turned ON at the same time. To listen to the output audio in headphones
or through speakers, click “MONITOR” to turn it on.
NOTE
(
When the USB settings for OUTPUT are set to ON as the livestreaming audio output destination, a warning message is shown. If this
happens, you must carefully read the message and agree.
(
If HDCP is enabled for the HDMI input signal, audio is not output to the [USB] port, even if the OUTPUT USB setting is ON. To output
audio, disable HDCP in the settings of your gaming device that’s connected via HDMI.
(
To monitor the audio through speakers or headphones, switch between the two by using the monitor select [b] button on the
operating panel of the ZG01.
32
Operations > Audio settings for livestreaming