User guide

30
Operation Method
Other Functions
Use calibration offset function
Calibration offset is a function which corrects the difference between the temperature in furnace
and that of controller (sensor temperature) if arises. The function parallel corrects the
difference either to the plus or minus side within the whole temperature range of unit. The
function can be set or cancelled by the SUBMENU key.
① Start operation with the target setting temperature. Check the
temperature in furnace (temperature of sample) with a thermograph after
it is stabilized.
② Check the difference between the setting temperature and that in furnace
(temperature of sample).
③ Press the SUBMENU key. Select the character "cAL", which indicates
the calibration offset, using the "▲▼", and then press the ENTER key.
④ Input the difference using the "▲▼" and then press the ENTER key.
This completes the setting.
 The setting range of offset correction temperature is +99℃ to plus side and
-99℃ to minus side respectively.
When it is set to the minus side, the temperature on the measurement
temperature display screen falls by the setting temperature, while the
temperature on furnace rises.
When it is set to the minus side, the temperature on the measurement
temperature display screen rises by the setting temperature, while the
temperature on furnace falls.
 The unit has two-point correction function, which performs offset between
low-temperature zone and high-temperature zone. Please consult our local
branch office when carrying out validation of temperature controller.
Use lock function
This function locks the operation status previously set. The function can be set or cancelled by
the SUBMENU key.
① Press the SUBMENU key. Select the character" "Lock", which indicates
the lock of setting value, using the "▲▼", and then press the ENTER key.
② The setting temperature screen displays "oFF". The setting value is
locked when it is turned to "oｎ" using the "▲".
③ Press the SUBMENU key again to cancel the lock. Select the character"
"Lock", which indicates the lock of setting value, using the "▲▼", and
then press the ENTER key. Select "oFF" with the "▼" and then press
the ENTER key to cancel the function.
 All keys other than the START/STOP and SUBMENU keys are lock when the
lock function is on.
Current temperature
Corrected temp. to plus side
Corrected temp. to minus side