Instruction manual

VF2400

5. Proper operation

5.11.2 Feeding amount of elastic tape

Fig. 5-17

②

①

Fig. 5-18

③

④

⑤

⑥

Ｌ

Ｓ

Before operating, ALWAYS turn the power switch OFF

and check that the machine has already stopped.

Loosen the nut ① and adjust feeding amount while check-

ing the pointer ② and the graduations of the clutch lever

③ as below.

● To increase feeding amount, turn the adjusting screw ④

clockwise and move the pointer ② in the direction “L”.

● To decrease feeding amount, turn the adjusting screw

④ counterclockwise and move the pointer ② in the di-

rection “S” .

Tighten the nut ① securely after adjusting.

If required feeding amount cannot be obtained by above

adjusting with the adjusting screw ④ , loosen the screw ⑤

and adjust it as below.

● To decrease feeding amount, turn the adjusting screw

⑥ clockwise.

● To increase feeding amount, turn the adjusting screw ⑥

counterclockwise.

After tightening the nut ① , turn the adjusting screw ④

clockwise to tighten it securely without play.

ATTENTION