Owner's Manual

6
Section 4 Wear a heart rate belt
Fig. 1
It is recommended that you apply a small amount of water to
the electromagnetic area on the back of the elastic band before
wearing it (especially when the skin is dry in winter).
Fig. 2
Install the heart rate sensor on the snap on the front of the heart
rate elastic band. And ensure that the installation is rm and
accurate.
Fig. 3
Pass the heart rate belt around the chest, just below the chest
muscles, and connect the hook to the other end of the elastic
belt.
Fig. 4
Adjust the length of the elastic band to your comfortable
wearing state.
Fig. 5
Make sure that the wet electrode area is close to your skin,
with the sensor in the center and the top facing up.
WARNING
!
Aer use, be sure to wash the elastic band with tap
water aer removing the sensor from the heart rate
band. Because sweat and moisture will keep the
electrodes wet and keep the heart rate sensor on,
this will shorten battery life.