Owner's Manual

7
Section 5 Computer use
• With these computers you can extend our trampoline to make your exercises even more eective. It
provides important information such as your pulse rate, number of jumps, training time and your calo- ries
burned. If the number of jumps is not equal to the number of jumps possible aer tensioning the spring (
snap hook )
• To turn on your computer, press the Mode or Reset button.
e display shows the time and the number of jumps ( count ) by default. Both values are initially set to 0.
During your training you can decide which value you want to display. Press the Mode button to switch
between the following values:
•
Pulse
Shows your current pulse. Please note that only one value will be displayed here if you have fastened your
chest strap and placed it correctly.
• Scan
With this setting the display changes every 5 seconds between Pulse / Time / Calorie.
• Time
Time spent in your current training session
• Calorie
Your calories consumed so far are shown here. Please note that this is an estimated value and actual con-
sumption may vary.
When you leave the jumping surface of the trampoline or stop jumping, the data is paused. If you do not
continue your training within 3 minutes, your display will go into standby mode.
In this case, you must press the Mode / Reset button to turn on the computer again. You can then contin-
ue your training with the previous values.
To reset the values, press the Reset button once.